Intlwaters
22 FOLLOWERS
RC boating community discussion forum & RC boat classifieds. Radio & remote control boat forum for motors, props, finishing, electric, engines, race schedule.
Intlwaters
16h ago
So where can the propeller repitching tools be found to buy...and what are the proper names for them..i know one has the dial indicator ..and the other is the block with many steel balls...
May as well get the tools...looks like I'm in it for the long haul ..read more
Intlwaters
16h ago
This is a very good prop for a mono hull running a gas big block engine. It is a modded 2817/3 19* .50 prop. The 7016/3 prop has always been a good mono hull prop. But one thing bad about the 7016 is it is a high lift prop. A lot of hulls will run wet in the bow with a high lift prop. That is why you see a lot of 7016 props that are modded called a 7016LL prop. LL means low lift. But this prop is a 19* low lift prop right from the start. No back cutting to get the lift out and removing a lot...
Read more ..read more
Intlwaters
1d ago
Motor is new header is new nova just cut to length. It’s a 15 degree. Pipe is a used nova. $400 plus shipping. PayPal ff or pay the fees. Cross posted ..read more
Intlwaters
2d ago
You all have been asking.......well here it is. Now all you scanals can get you info from David.
https://www.newtonmarine.com ..read more
Intlwaters
2d ago
I am building a scale and are in need of some detail pictures of the driver's cockpit and engine. The boat I am doing is the 1968/1969 Bardahl. I know that this boat has been done a lot. But I got to see it run those years in Guntersville, Alabama. What a beautiful boat running to see in person. My email address is markbullard@emipower.net. Thanks ..read more
Intlwaters
3d ago
Novarossi TO-BE .67 DDA for sale
New Crankshaft
New Piston and Sleeve
New latest gen con rod
New bearings throughout
New head button- turbo
New cooling cap
No damage to case
$325 + S/H
Zelle, PayPal....buyer pays fees ..read more
Intlwaters
3d ago
My 1/8 scale 1982 Pay N' Pak turned out great but it needs to be finished up to get her on the water and I don't have the experience necessary to make that happen on my own. I live in Astoria, Oregon and am looking for someone with FE hydro setup experience within a 50 mile radius (can extend that for the right person) who can help me finish her up.
The motor is installed, ESC needs an EC5 connector soldered, I have a Futaba radio and receiver. Probably need a better prop too. I can...
Read more ..read more
Intlwaters
4d ago
These are all sharpened and balanced props. They are 1.8, 1.9 and 2.0 sizes. You can see the sizes listed in the photos. The two blade props are $49.95 each and the three blade is $59.95. The USA shipping is $6.00 ..read more
Intlwaters
4d ago
I have a New no fuel never ran GZ 28.5 Pro Mod motor with EZ start / gizmo mounts and collet for sale. I don't have the timing numbers but it was build for my Sport Hydro. I also have a used but like new Hot Pipe with the exh. cooling flange and two more inserts that I would like to sell with the motor. I'm asking 625.00 for both Plus shipping. I will take the mounts off for shipping. These will be listed on other sites.
Thanks...
Read more ..read more