I've been looking for the right truck but most of those that I wanted cost more than I was willing to spend. I found this one, a 2022 Ram 1500 EcoDiesel 3.0 L that has literally every available option. It only has 13k miles on the truck and was a Ram Corporate Vehicle in Michigan. It still had the protective plastic from the manufacturer on the rear seats and all the little extra bits were also still factory packaged. I found it up in Orlando and jumped on it as it was over $10k less... Read more ..read more

Hi All, General advice needed. My 2014 750D with DCT has developed a thump in the transmission. Sounds BAD, something trying to get out, by the sound of it. I'm thinking out a replacement engine gearbox unit if something is available somewhere. I am in Melbourne Australia, there were only a small number of these sold here, can't find anything in wreckers, thought I would just ask the question here about the possibility of something there????? The bike has about 75,000 km's on the clock so a... Read more ..read more

New member here. Looking to buy a used NC750X for use as a 1-up rider when my wife isn't going with on the Goldwing trike. Spotted a 2018 with low miles that I may take a look at in the next day or two. It's a manual, which I prefer, so that's good. The one I'm looking at has no OEM Honda saddlebags or travel trunk. First question: How likely is it that I can still buy those accessories new directly from Honda? Possible, or not likely? Second question: What's the difference between... Read more ..read more

Hello, anybody ever installed an auxiliary tachometer on their NC? I would like to put a big round old school tach on mine that can be seen at a glance. Would like to know of anyone's experience with this and preferred units, wiring issues etc. Thanks, Guy ..read more

I know this is a long shot but does anyone have a Shad seat for a NC750X they would like to sell? Fair price paid. PM me ..read more

SOLD on April 28, 2024. I'm now changing this to $80, from $160, all proceeds will go to the forum. You can send you payment as a forum donation or pay me through Paypal and I’ll make the donation. I'll cover the shipping. I bought this windshield earlier this year when I thought I would get a new NC750X, but no current models were available. I finally found a 2018 in Everett in July. I got a new windshield for the 2018 model. The 2018 Madstad is very easy to put on, while the 2021... Read more ..read more

Hello I'm Donk. The Ferret made me do it! Bought a '21 NC750X 6speed manual. Really like the bike A LOT. I have a couple other bikes too, KTM 890 Adventure, MT-10SP and an FJR ..read more

I have a side stand foot enlarger that fit my 2012 NC700. I had my stand replaced and now it doesn’t fit. I don’t what the shop put on but now I can’t use this. I’ll give it away as long as I can get about 7 bucks to ship it ..read more

I have a complete set of brackets that came off of a 2018 NC750. I bought these from one of the members here but it did not fit my 2012. Some of the bolts may not be correct, I switched some to use with my new brackets. I would ship these anywhere in the contiguous US for $75.00 ..read more

Does anyone have the OEM handlebar dimensions? My 2013 came with aftermarket bars and I am wanting to see how they compare to the OEM bars. My current bars are 26-3/4" wide, 4" of rise, and 5" sweep. The sweep is really bothering my right wrist, it is causing tingling/numbness in my right hand. I am wanting to do some longer rides, but so far 60 miles as far as I an go with the current bars. I have been looking for some different aftermarket bars, but all the bars I have found so far... Read more ..read more