Hi, My 14 year old son broke the recline on the passenger captain's seat in our 2017 Vista 29VE. Unfortunately the recline mechanism is a welded attachment to the frame on these seats. Not a great design. The fabric on the chair is fine so I ordered a replacement frame from Lichtsinn. The part was $250 and the shipping $200! I tried to see if I could swap out the broken frame for the new one myself but quickly realized its going to take a professional upholsterer. So far one guy wants $850 to take the old frame out and put my new one in and then attach all the foam and fabric appropriately. I ..read more

How do I replace the back flow valve ..read more

I used a S SATCO rubber wheel to remove graphics from the side of my Itasca. Comes off fast, but left areas of tan residue/staining on the white finish. Did not come off with Acetone. Any suggestions on how to remove it? Attachment 188852 Attachment 188853 Attached Thumbnails   Attached Images   ..read more

Is it possible, to easily install cameras where the back side marker lights are? Sooeey ..read more

My 2016 Via leaks where the gravity fill line attaches to the neck of the tank. I'm hoping someone here can give me a fix without having to drop the tank. The leak can be "Felt" but not seen. Hoping there is a clamp that might need tightening ..read more

Category: Dumb Question Is there a fan above the range of 2018 Vista 32YE ..read more

For those of you with Meridians and Journeys on the Freightliner chassis, what do you store on the rear compartment on the righthand side of the coach? It is long and fairly shallow. And I suspect it may get pretty warm due to it's proximity to the exhaust and SRC. Aaron:cool ..read more

I own a 2017 VIA Class A on a 2016 Mercedes 3500 Sprinter Chassis. The drivers side fog light is out. I can't seem to figure out how to remove the light to replace. There are 2 phillips screws on the sides of the bezel but how to access them seems not very easy due to the fact the whole fog light assembly is blocked by the bumper frame. Looks like access from the bottom would also be a bear and a half. Any suggestions would be GREATLY appreciated. Thanks! FloridaJack ..read more

Having an issue with a 2022 32m back rear wall warping? The warping goes side to side right through the center of the heater vent. It seems to be causing the heater cover not to mound flat against the wall because the warp has caused a ridge which peaks in the center of the heater cover. I went on-line and found several other 2022 32m’s with the “same exact warping issue.” Is this a Winnebago manufacturing issue? Will Winnebago stand behind the repair ..read more

Simple one guys. My windshield washer signals on my dash that the fluid is empty and it's full. Do I need to buy a new sending unit that goes on top of the tank. Or is there something else going wrong? Thanks Guys and Semper Fi; Jim ..read more