PakWheels » Corolla
66 FOLLOWERS
PakWheels is Pakistan's largest discussion forum for cars, a place to ask, answer and discuss about anything and everything on wheels.This is a model specific section for discussions revolving around Toyota Corolla.
PakWheels » Corolla
2d ago
@engnr.mubashir wrote:
I want to ask is it good decision for someone to opt for 2zz ge instead 2zr fe with CVT transmission.
One more thing to ask what is cost of swapping of 2zz ge with transmission these days.
Posts: 6
Participants: 4
Read full topic ..read more
PakWheels » Corolla
3w ago
@pwuser148688842832 wrote:
Hi all,
I am planning to buy a car in low cost and restore it as close as possible to factory specs do you guys think is it worth it and how much will it cost? Most of used cars now a days from this model are showered below roof or including roof from outside so instead of buying those at insane price I have planned and getting an Xli Lahore registered in around 16.5 lakh so if I spend 200K on it to get it a new life isn't it going to be worth the effort? Please give your suggestions.
Posts: 4
Participants: 2
Read full topic ..read more
PakWheels » Corolla
1M ago
@malikabidrafiq wrote:
I have Corolla GLI 2017-2018, can go to install Cruise Control with it. Is there connection to installed Cruise control kit.
Posts: 1
Participants: 1
Read full topic ..read more
PakWheels » Corolla
1M ago
@pwuser166073153329 wrote:
hi i need to buy CANBUS for my corolla grande 2016 model to connect it with my car andriod player. please adivce where it is available. i have searched but couldn't find ti
Posts: 1
Participants: 1
Read full topic ..read more
PakWheels » Corolla
2M ago
@pwuser163568184736 wrote:
Hi there, After driving my car for almost 49,000 kilometers, I'm planning a service and maintenance at 50,000 kilometers or sooner (perhaps in the next few weeks). Help me please, and it would be greatly appreciated if you could add important things to note for when the mileage reaches 50,000 kilometers.
The brief history is as follows:
* I've been using Mobil1 5w30 from the beginning, and I replace the engine oil every 6000–7000 kilometers.
* At 40,000 km, the transmission oil was changed.
* At 37,000 km, the tires were replaced.
* At 30,000 km, the front brake pad ..read more
PakWheels » Corolla
2M ago
@ali199 wrote:
Hello all,
My Corolla Gli 2019 model has good sound but lack (rich) bass. I don't need loudness but at least some bass at lower volumes.
I opened its door and found that it already has reasonably good speakers (built-in tweeters). I suppose these are 40-55w speakers.
See the imagea below:
IMG_20240117_140322.jpg4624x3472 3.78 MB
IMG_20240122_173736.jpg4624x3472 4.71 MB
Is my requirement met by just changing speakers? Or head unit? Or both?
Please suggest if any of you guys have experience or have upgraded some.
Posts: 3
Participants: 3
Read full topic ..read more
PakWheels » Corolla
3M ago
@abdulrehman122 wrote:
Hello dear members
please advice where to convert my hydrolic steering to EPS and what it would cost me
thanks
Posts: 1
Participants: 1
Read full topic ..read more
PakWheels » Corolla
3M ago
@hassanbaloch1997 wrote:
I bought corolla Gli 2006 petrol engine about 6 months ago. It was in very rough condition. I maintained it mechanically. But still i get 10 to 11 km/ ltr fuel average. The car also needs body work denting as well as painting too approximately 2 lacs will be needed to make it in perfect condition.
I am not satisfied with fuel average. Also body work is needed. is it a good option to go for denting painting and investing another two lacs or should sell the car and buy another one.??? Also suggest about fuel average. Please corolla 2002-2008 lovers your expert opinion n ..read more
PakWheels » Corolla
4M ago
@mabdulrafe428 wrote:
The watch at the dashboard of my corolla altis has gone slow probably because of weak battery. How can I change it. Thanks
Posts: 1
Participants: 1
Read full topic ..read more
PakWheels » Corolla
5M ago
@engnr.mubashir wrote:
So spark plugs wells were filling with oil so I decided to change valve cover gasket after changing it and running for couple of KMs it started to seeping oil don’t know what went wrong even though I properly and carefully placed valve cover gasket and tightened bolts according to Chris cross pattern.
Also properly cleaned surface of gasket placement.
Can anyone guide me in this regard what to do to prevent it.
Posts: 3
Participants: 2
Read full topic ..read more