I purchased a 2000 Jeep Wrangler se 4 cylinder. Steering gets squirrelly around 50 mph. I have replaced the track bar, the steering stabilizer, and made sure everything is tightened. However, still having issues with the steering. Can anybody offer any advice ..read more

I purchased a 2000 Jeep Wrangler se 4 cylinder. Steering gets squirrelly around 50 mph. I have replaced the track bar, the steering stabilizer, and made sure everything is tightened. However, still having issues with the steering. Can anybody offer any advice ..read more

06 tj 4.0 ltr can’t find were to plug in B2S2 02 sensor. Old one wires were cut, just bought it and has code poo58 ..read more

So, I have a 97 Jeep wrangler TJ, bought some new LED tail lights to add a lil extra to its appearance. Problem- OEM has 3 wires (gray/black, white, green/black) New LED lights have 4 wires (red, white, blue, green) I can wire them up as I think they work, (which brake, turn, driving all work) but no reverse lights.... What wiring config do I need to use to get everything to work? Kinda baffled ..read more

I've been looking really hard to try and find doors in good condition and I have recently found some great doors but there on a 1990 yj and I own a 98 tj. Before I pull the plug and buy them, can anyone tell me if they'll even fit ..read more

Does anyone have an opinion ? Junk? Harbor freight has a 12,000 pound synthetic rope winch for $249.99 it was marked wrong it’s the 5500lbs ..read more

Does anyone turn OD off on the highway? Seems like my trans shifts in and out of OD a lot when going 65 and above. Seems hard on the trans to me. Im debating on just shutting OD off. RPMs at this speed is only about 3k. Thoughts ..read more

I've had to replace my left hood latch twice in less than a year and it's broken again. This happens when I pass an oncoming semi or other large vehicle. It's my back-up mail jeep- I don't even drive it that often- and I'm tired of having to stop to gorilla tape it down to get me through my route. I ordered the latches from rock Auto- is that the problem? Are there better quality latches to be had ..read more

I have a 1988 Jeep Cherokee 4.0L. Runs great for the mileage it has. Just wanted know if there was anything I should know now before I start actually doing any work on the engine. Also I'm looking for an intake plenum for the AMC 242 and I'm not seeing anything online anywhere. Mostly looked on summit racing and haven't found anything I can use. Also heard that the engine used a Renix system, don't know what that is yet but I'm sure I'll figure it out soon ..read more

runs good. but as she warms up it will sputter. matt her to the floor she recovers. what sensor is out ..read more