I need 4 15X7, 5X114.3, 70.5mm center bore wheels. I am located in FL ..read more

I need help troubleshooting my 2009 Ford Ranger four-cylinder XLT 2 Wheel Dr. my RPMs at idle are 850. And my O2 sensor is going from lean to rich every second I have 113,000 miles and I replaced both upstream and downstream O2 sensors and I replaced the idle air control valve and I cleaned out the mass airflow sensor. View attachment 314 View attachment 315 View attachment 316 View attachment 317 ..read more

считаю верным выбором для SEO ..read more

отмечу как доверительного союзника в SEO ..read more

I just have a question on the jumper for the resistor on the back. The resistor mounted on the labeled “Oil” lands has a 190 ohm resistor which measures 134.8 ohms. It is a 1% resistor and that is no way in tolerance. If I jumper, take it out of the circuit will my gauge work correctly with the appropriate sender? My truck is a 1997, 2.3L. I haven’t found the switch on the back of the motor, on the passenger side as there doesn’t seem to be anything located there. Where do I install the PS60... Convert Oil Pressure Switch to pressure gauge ..read more

Heys guys. I’m trying to find out if there is an aftermarket or a newer Ranger model steering wheel with radio volume controls on the steering wheel that I can mount onto my 1998 Ranger? Thanks in advance ..read more

HI ALL, NEW TO ME 2005 FORD RANGER EDGE, V6 4L 4X4 LOOKING TO INTALL NICE BACK UP CAMERA (WITH THE GREEN/RED LINES) INTO THE REAR VIEW MIRROR THAT FILLS THE ENTIRE MIRROR NOT A SMALL PORTION OF THE MIRROR. ANY EXPERIENCE OR SUGGESTIONS ARE WELCOME. MUCH APPRECIATED ..read more

I have a good 4.0 that id like to swap into my 93 which came with the 2.3 with manual transmission. My question is will my manual transmission bolt up to the 4.0? Also any other info pertaining to 2.3 to 4.0 swap would be greatly appreciated. I NEED MORE HORSES UNDER MY HOOD! PLEASE HELP ..read more

Hi, Guys. Can any one tell me does a 2019+ ranger have a split bench ..read more

Ok guys I have a 98 ranger 2.5l 4speed o/d with 3.73 gears in rear end I come out the hole fantastic but when I get to 70 I struggle to go anywhere can yall be so grateful to tell me if I swap rear ends will it go faster and if so which rearend and gears should I put in it P.s. I pull a 5x10 utility trailer every now and again not often Thanks for advice guys ..read more