On my combine we'll be going an then where the gears are displayed there will be a x there instead of what gear you are in an if you stop the combine it'll say gearshift unsuccessful if you shut it down for twenty minutes an start it'll sometimes work ! I've replaced the sensor on top of the transmission also but that didn't help has anyone else ever had this problem ? Any input would be greatly appreciated ..read more

Will only shift gears with clutch pedal depressed. From a standstill or moving. You can only shift gears up or down with clutch in. Any help before getting the stealership out would be appreciated ..read more

Hello. I have a problem with my new holland. Has anyone encountered such a case? I can't find what this error means. E-0195-11 FOOT AN INCH. I will add that we replaced the bearings in the gearbox because the first gear did not work. now the gear works, but sometimes when the combine harvester is drive such an error appears ..read more

has anybody put a antenna amplifier on there 900mhz Trimble RTK base station? or is there a different way to get more reach from the base station ..read more

Hey all is it just me or does it seem like Now case built a big new different style quadtrac, Newholland kind of took over their old style quadtracs, including adding the swing out steps, fender fuel tanks, Solid mounted tracks, ect... So now even more so it's just eye appeal or am I wrong ..read more

"Wanted! We are seeking someone who has the expertise to disassemble a New Holland TX series combine harvester and prepare it for shipping by placing it into a 40ft container. The location for this service should be in Saskatchewan or Manitoba, Canada. If you possess the necessary skills and facilities for this task, please reach out to us. any leads are also appreciated. Thank you!" TeamEquipment44@gmail.com or 705-206-0197 ..read more

I bought a TR86 over the weekend with a corn head, but I still need a flex head for beans. It looks like I need a 972 or a 973 but I want to make sure. What model of flex head do I need? Can you get a model 972 as a flex head, or were they all rigid heads? Thanks, Brad ..read more

Hi all, I'm looking into a fault that's coming up on the intelliview 2plus screen on the machine, "right/left spreader speed sensor disconnected." Is what's coming up all the time after start up. Can anyone help me as to where to start with this as my general look at the moment tells me there's not much as far as sensors on the spreader chopper system. Thanks in advance ..read more

..read more

Has any put the slow down kit on a 2018 or newer CR? CNH and Redekop both make them, they take the chopper speed from 4000rpm to 2700rpm I believe. I have found the higher speeds have a lot more vibration and problems. I'm wondering if the straw chopper spreads worse or is it just as good? TIA ..read more