My Tractor Forum » John Deere Forum
136 FOLLOWERS
A forum community dedicated to all Tractor owners and enthusiasts. This section of the forum is a place for talking about John Deere Garden Tractor.
My Tractor Forum » John Deere Forum
1h ago
Does anyone know what size the diodes are on John Deere 265 wiring harness down by the relays ..read more
My Tractor Forum » John Deere Forum
4h ago
Changed all fuel lines, pickups in tank, fuel filter. Tractor runs and starts on level ground, when cutting on a slight hill filter runs out of gas, filter will not fill with gas when you try to start it on angle. Put on level ground filter fills with gas when you star it. Tried reserve pick-up still same results ..read more
My Tractor Forum » John Deere Forum
13h ago
So I came across a lx279 today that's been sitting for 10 years because supposedly the "brain box" went bad in it. So they bought a new one. I checked it out. Hood is missing but deck is there and all spindles move freely. Doesn't look rusted out. It's been in a shed for 10 years so covered in dust. Didn't see an hour meter. Coolant was full. Oil was barely any on stick. Owner says it ran fine before "brain box" went out of it. Is there anywhere on these engines where mice can get into the...
What to look for on a john Deere that's been sitting for 10 years ..read more
My Tractor Forum » John Deere Forum
14h ago
I have replaced the fuel filter and carburetor today. And upon attempting start it (everything was put back to spec), the flywheel fan fins mysteriously sheared off and it's not sucking fuel in, found out about the vacuum fuel pump so that's taken care of. But now the gas pedal is stuck and won't move at all, cant press it down whatsoever. I'm stumped, any advice would be appreciated. Thank you ..read more
My Tractor Forum » John Deere Forum
15h ago
Hi All,
This is on a 38" mower (all hardware was on the 165 Hydro). Ive mounted it on the 185.
What drive belt length should it be from the main deck pulley to the electric PTO?
Ive seen listings for 60, 61 and 63"
Any thoughts?
Thanks ..read more
My Tractor Forum » John Deere Forum
19h ago
I would like some help on the steering shafts replacement ..read more
My Tractor Forum » John Deere Forum
1d ago
I've got a 165 that's beyond saving, but it came with a 38" deck with the 4 bolt spindles. The deck shell is in decent shape, but every bearing is seized, and I don't have the belts or else I'd just test fit it. I also have a 180 that runs and drives, but doesn't have a deck. The parts manuals on weingartz show that the 165 could come with a 38" deck with either the 3 bolt or the 4 bolt spindles, but the 180 only shows the 38" deck with 3 bolt spindles. Does anyone know if this 165 38" deck...
165 to 180 deck and axle interchange ..read more
My Tractor Forum » John Deere Forum
2d ago
Can easily turn steering wheel in either direction as many times as I want without engine running. The front wheels do not change direction and the steering wheel feels like I'm turning across a series of small ridges. Anyone have a recommendation as to cause/fix? Thanks, Nubie Tom ..read more
My Tractor Forum » John Deere Forum
2d ago
I am going to be in MN in Sept and wanted to know if there is a JD boneyards near the St. Paul area? Thanks ..read more
My Tractor Forum » John Deere Forum
2d ago
Well the title says the problem…
I was mowing some tall grass and I noticed it wasn’t pulling hard… come out of the tall grass and boy did it take off…
So before I blow it by running wide open I need to get it fixed.
The engine has been rebuilt from top to bottom 15 years ago and only 25 hours at the most on it ..read more