Hello everyone, Just wondering if the NAD C399 pre outs will have enough juice to run the Nilai mono's cleanly. I did some research but I'm still not sure. Thanks ..read more

Hello everyone, A little confused on the power ratings on the purify amplifier. On the review, the 8 ohm and 4 ohm power ratings on the purify look low compared to the m33 and 23. My understanding was that the purify amp was just as good if not better in power output. If I recall correctly, the purify put out 154 watts 8 ohm and 200+ 4 ohm. and the Nads amplifiers put out well over 200/400 watts. I want to get the Purify 1te400a amp to match with my NAD C399. I was originally going to get... Read more ..read more

Hello together, i am thinking about to find the right amp for my speakers. Currently I am using KEF R3 Meta speakers and the amp should fit perfectly for the R3 metas. So I don't need to worry about the volume as the amp is every time able to drive my speakers without clipping (but not destroy the speakers). The KEF R3 Meta are 4 ohm loudspeakers regarding the datasheet vom KEF. But they dip down to 3.2 ohm at about 100-200Hz as measured by Erin. Link to Erins Test: Test R3 Meta... Read more ..read more

Hello, First post and first thread. My system is at the moment Streamer Eversolo DMP A6 ME, Pre-amp Classe Audio Four, Amp Classe audio Seventy and Loudspeakers Audiovector QR7. I do like my system, but since I changed to my new speakers, I tend to listen a bit louder and noticed that my amp (70 w/8 ohm) is starting to clip when I am listening around 80-85 db, so also because it is quite old, I am looking for a new amp. I was considering things like Accuphase E-380 and Hegel H390, but... Read more ..read more

Hello, couple weeks I enjoyed in new setup: Speakers: Rowen M8 SUB: Dynaudio sub 250 Amplifier: Yamaha MX630 Preamp: Vincent SA-32 DAC: Schiit Modius (first edit.) Streamer: Wiim pro I intend to test Bi-amping, Yamaha doesnt have so good low end (In my case SUB do this...), Now Im searching some budget AMP with good damping factor, only for lows...I like Yamaha sound for highs...want tight bass...(also will replace DAC, to Nad m51) looking for: Rotel rb990bx / 991bx... Any... Read more ..read more

Hi, What would be your ideal component combination for best performance, functionality, and reliability? Budget is under $5000 I will be music streaming mostly, some TV/movies. Preamp needs to have TV input, 2 sub out. XLR. Gain no more than 6-9 db has been suggested for preamp. Need: Pre-amp Streamer DAC Room correction Roon endpoint Simple for the wife to use. Some things that have been suggested to me so far in my research. Complete solutions: NAD m66 (checks all boxes... Read more ..read more

..read more

Not sure if this amp has been discussed here before, if yes please delete this thread I have just come across with this new amp from SMSL, the SMSL A50 Pro It is a 3-channel amp with a full adjustable crossover (both LPF and HPF) using the MA12070P chipset. Also DAC and BT integrated, there is even an ARC HDMI connection available. 2x70W at 4 ohm + 1x100W at 2 ohm All this for 90 dollars.... Would be great to see some measurements about it ... Read more ..read more

Grundig A-905 Has anyone used such an amplifier and what feedback do you have about it? I settled on this one for the power 2x120w at 8 ohms I need a powerful stereo amplifier and I don't know where to turn Поискайте помощ!!Аnd these are my speakers ..read more

B100 32 ohms, more than ten watts. Except for power, other parameters of this model are better than LA90D. The price of two units is lower than the price of one LA90D ..read more