My Bobcat dealer tells me that after market fuel filters will not work in the T595. It keeps setting water in fuel code and going to idle speed. Is this really an issue with non Bobcat fuel filters ..read more

Hello thanks in advance to anyone that helps or at least sheds light on subject many thanks indeed! I have a genie S45 when you bleed (Purge)the air from self leveling circuit after a week or so the basket will not self level.. Bleed the air is re fine another week or so then no self level again so on so forth... Where can air be getting into the closed circuit at? Manual level up and down both work correctly ..read more

Hi All, I got a bit of a problem with my Western Star, when air pressure is full it starts great. if sitting for a weekend and air runs out, when go to start the fan is locked and has a hell of a time starting. I did a rebuild on the Kysor fan clutch and checked solenoid, both working fine but I do not get that little air release when key turned on before starting which it used to. would this be a AC switch ..read more

Got a customer with a poorly D6T. Lost steering, pulled the steering pump and found the gear inside to be loose. We need to pull the torque converter housing to get access. What's the removal and install procedure for this? Serial - ZJB00506 ..read more

I knew when I purchased my rig that getting parts would probably be a challenge. I tried to use the dealer in my future home state. I wont name any names but suffice it to say I wasn't impressed. Hence my question. Do any of you have a good parts source for this brand? I would greatly appreciate it ..read more

Gentlemen... Question regarding sprocket wear. I just went and looked at a machine for a customer, before purchase. ( Lives 8 hrs away ) 2017 Deere 333E ( 3200 hrs ) Has brand new tracks. Right hand sprocket is worn AF. ( very sharp ) Left hand sprocket worn a bit, but nowhere near as much as the Right. ( Original sprockets ! ) Outside of poor metallurgy, what would cause one sprocket to wear out way faster than the other? Especially a machine with only 3200 hrs ..read more

So, having been looking for some rear tires on my Case 580 SE for awhile, I might have gotten lucky, maybe not. I have been watching tire prices on EBay and Simplytire for a couple of years. I just got 275/65/20” E rated tires on my truck last week, scored them on Simplytire for 132 bucks each, they are Armstrong and quite pleased with them for a cheap tire. Simply tire is very frustrating because it’s like a roulette wheel with prices. It seems if you take a week off from looking, the... Read more ..read more

I've never done a transmission swap on a case loader before but I have everything loose, and the tranny is ready to be pulled will it be easier to take the cab off and pull it out through the top or lift the tractor and pull it out the bottom ..read more

New Dyco Final drive $ 1200 Fits Kobelco SK03/K903 Model # 2441U532F1 Serial # 8912 Located Pearland, TX 77581 Cash, you pick up. Phone number corrected Can text me at 512-595-6144 ..read more

Hi guys, long time listener (probably 10 years), first time member/poster. There seems to be a ton of knowledge on these forums and I was hoping I could get some input from those with experience here. I'm in upstate NY and have a tri axle dump truck, 20 ton tag, a 450 deere dozer and a jd310 backhoe, also recently bought a pete 379 road tractor that I'm going to get an end dump trailer for. I frequently end up with leftover material from jobs, and in many cases take the last load of fill at... Read more ..read more