Negative frequency + sound like old radio.
MYCNCUK
by hamoooud031
2d ago
Hi for everyone after big boom on the first VFD. I'm trying to marry the New vfd with same characteristics ( 220 v / 380v 2.2kw CHINT) and the two spindles with no support no information no data sheet.... according to mr google... It's : 2.2kw 380v 24000rpm 400Hz 2 pole and I have set the Motor Stator Impedance to 6 homs. Everything went well But i noticed two things 1) the display shows negative values 2)strange sounds like an old radio PS I am a mechanic so electricity is a bit difficult for me. it is a machine for smoothing the edges of wooden plates. it's my brother's machine...i appreciat ..read more
Visit website
EBay: Tormach PCNC1100 + Accessories
MYCNCUK
by JTulley
1M ago
https://www.ebay.co.uk/itm/385592863236 ..read more
Visit website
In Need of AXYZ DNC exe pls
MYCNCUK
by Arpad
1M ago
Hi all, Got a AMC controlled AXYZ 6010 router and would love to test files sent to the controller but I don't have the DNC on the disk supplied with it. Would appriciate any help. Thank you ..read more
Visit website
Ideas for an upgrade build
MYCNCUK
by Dazi
1M ago
Hi everyone I've just purchased one of these (https://www.facebook.com/photo/?fbid...00063881355248) and it needs upgrading to Mach3/4 i have a few new but never used parts lay around from another build that didn't happen, eg Ethernet smoothstepper, also a PLC4x-G2 breakout board and 3 x Leadshine EM806. Was just wondering should i use these parts or start again? the machine has (just roughly measured) 4 start 12mm or 1/2" pitch screws on X and Y which seem a bit coarse so not sure what motors to go with. at the moment they are Nema 23 bolt pitch. I will be mainly machining oak and the odd pie ..read more
Visit website

Follow MYCNCUK on FeedSpot

Continue with Google
Continue with Apple
OR