Just purchased this piece for a measly $800? Was it a decent deal in your opinions? Made in '92 looking the serial up, jm stamped Any info about the model would be cool too! This is my 2nd lever gun, complimenting my model 94 submitted by /u/PeeTree93 [visit reddit] [comments ..read more

Hey guys, I just got an 1897 but I am missing the screw that holds the magazine tube to the barrel. I have tried the usual sites and havent found anything. Any suggestions? submitted by /u/Temporary_Evening_32 [visit reddit] [comments ..read more

Evidently my model 60 marlin semi auto .22 is a one off yr. I only see one confirmed case of a model 60 marlin 22 with the prefix MM. From the site oodmag.com I saw the info """As of late 2013, a Marlin .22 RF rifle (XT-22 Mag) had a serial number prefix of MM reported and verified. It is unknown as of December 2013 how Marlin ("Remlin") will continue with their serial numbering convention"" I want to buy parts for my .22 but I can't decode the serial number to tell me any information. The barrel says "" THE MARLIN FIREARMS CO. MAYFIELD KENTUCKY USA MODEL 60 MICRO - GROOVE BARREL CAL 22 LR ON ..read more

I have a marlin 1898 in the shop to be deemed safe and ensure all parts are safe and in working order. According to my Gunsmith it is one of the earlier models, I believe that it takes 2 5/8 black powder shells. Am I correct? And if so where can I find such shells or shells that will be fireable. I'm fully aware of the safety concerns so please leave that out of the equation. This gun will mostly sit on display but I want to be able to shoot it in my field every now and then submitted by /u/LILZMAN5454 [visit reddit] [comments ..read more

submitted by /u/CFerrell82 [visit reddit] [comments ..read more

when did Marlin sell out to Ruger? i just noticed the "Pre-Ruger Manufactured".. ​ https://preview.redd.it/cbw0w4lpffcc1.png?width=2880&format=png&auto=webp&s=75ef5dd35bea362d701fe42732b06aea5c6e600f submitted by /u/CreativeForever841 [visit reddit] [comments ..read more

I recently got the Rapido Plus Hotend but i cant find any sort of documentation how i set it up in Marlin firmware. The hotend uses the PT1000 thermistor. The Printer is a direct extruder Ender 3 V2 with Ldo Orbiter 2.0 and the Phaetus Rapido Plus Hotend. submitted by /u/Realistic-Weekend348 [visit reddit] [comments ..read more

This is my first time updating firmware. I've upgraded to the SKR Mini E3 v3 and also gone for the MicroProbe at the same time. I'm in the process of configuring the firmware following the instructions from the BTT github and I've gotten to the point where I have to set the Z_MIN_PROBE_ENDSTOP_INVERTING to true but it's missing completely from the config file. What do I do? submitted by /u/sMiLEy_sLOth [visit reddit] [comments ..read more

I can’t find anything online that can help me. Has anyone ran into this problem before submitted by /u/tony1119 [visit reddit] [comments ..read more

submitted by /u/moff_sploder [visit reddit] [comments ..read more