SecurityCameraKing.com CCTV Forum
249 FOLLOWERS
Get answers to all your surveillance security camera and access control questions in one place. Security Camera Kings online support forum has 24 hours fast and expert advice.
SecurityCameraKing.com CCTV Forum
1M ago
I have a new Elite 4CH NVR system to use at our church that has no internet. When I plugged the 4 ip dome cameras (Anpviz IPC-D250W-SE)
into the NVR it doesn’t detect them. What do I need to do to get them to work.  ..read more
SecurityCameraKing.com CCTV Forum
6M ago
I've been gifted an HDPTZ-ELS2IRL25X camera and want to run it on my existing NVR-ELE16M-16P4KV2 network recording system.
Is this possible, and if it is, what hardware do I need to make it work?
Thanks,
Tubac
  ..read more
SecurityCameraKing.com CCTV Forum
7M ago
DVRs and NVRs can be loud. Does Security Camera King make a quiet or fanless NVR for Ip cameras?
Thanks ..read more
SecurityCameraKing.com CCTV Forum
8M ago
Hopefully someone sees this soon... (Jordan maybe:-)
We set up people counting on one of our NVR's for our event this weekend. It is working great but not generating reports in SmartPSS or on the local UI. We have to be sure to look at the count before midnight as it is showing on the live stream on the local monitor only.
What are we missing in the setup to get these reports so they don't all say zero?
Please advise!
Mark ..read more
SecurityCameraKing.com CCTV Forum
9M ago
Did a cursory search and found nothing on this...
I am involved with a large organization and we have a lot of Elite NVR's and camera's on our property.
We have a need to count visitors coming onto our property and we have 16 channel Elite NVR in the entrance area.
Currently we have that area covered with Elite Vandal Dome camera's. We use Elite Bullet camera's in some area's as well.
What I need to know is will any of these camera's work for people counting, or is there a specific camera I should install in the high traffic area, a 4' wide aisle where upwards of 10,000 bodies will pass ..read more
SecurityCameraKing.com CCTV Forum
9M ago
I am glad that was it and not the unit needing to be replaced.  ..read more
SecurityCameraKing.com CCTV Forum
9M ago
Jose,
Turns out it WAS the power supply.
Thank You Very Much ..read more
SecurityCameraKing.com CCTV Forum
10M ago
Do you have another 12VDC 4Amp or higher power supply? As aforementioned the adaptor may not be providing ample amperage.  ..read more
SecurityCameraKing.com CCTV Forum
10M ago
I plugged in the new surveillance drive and it's still not seeing a HD.  ..read more