Passenger side front window switch
Chrysler Forums
by Stuvpro
2d ago
On a 2013 Town & Country, I am seeking to find out if there is some other issue with trying to get the passenger door window to power down or up from the passenger switch. I have tried replacing the switch assembly three times (that also has the door lock switch) but no luck. The doors will lock and unlock ok with the new switches, but the window will not respond with the replacement switches. The window will power up and down with the driver side master switch, so the motor is good ..read more
Visit website
Oil pan removal procedure '92 lebaron 3.0 conv
Chrysler Forums
by Irishstew
1M ago
Hi all, unfortunately hit a rock and cracked my oil pan. It needs replaced and I can only do this in my driveway. Does anyone know how to do this? Or can you provide any hints, tips or tricks? I read that the front end of the car has to be raised and that the engine mounts have to be removed and the engine supported either from above with a hoist or from underneath with a jack. I want to do this safely and I'm hoping that someone out there has done this before and can shed some light on it... Oil pan removal procedure '92 lebaron 3.0 conv ..read more
Visit website
Fuel pump replacement on a 94 new yorker.
Chrysler Forums
by 94 New Yorker
2M ago
Do ya have have to lower the fuel tank? Thankyou ..read more
Visit website
Cabin Air Filter
Chrysler Forums
by jacek1
2M ago
Is there a Cabin Air Filter in 96 Concorde LXi ..read more
Visit website
Dead no crank
Chrysler Forums
by Unameit
3M ago
I have a 2008 Chrysler Sebring the wife was driving it turned a corner to go into a parking lot and the car quit, dead no crank. So I bought a new ignition switch which I was installing and I noticed that there is a wire coiled around the key housing where the signal from the key is read. It leads into the wiring harness and the skreem looks like it's been cut off where the collar would go around the key and that is where this wire is wrapped around. The skreem box is there and has 2 fine... Dead no crank ..read more
Visit website
1994 Key Removal
Chrysler Forums
by Doycon
3M ago
I can't remove my key from my 1994 LeBaron. Can anyone help ..read more
Visit website
Rim sizes?
Chrysler Forums
by DaRook
3M ago
Will the rims from a 1997 Sebring convertible fit onto a 2006 town and country? I need tires for my van and have new snow tires on the lawn art I'd like to use. Any help would be greatly appreciated ..read more
Visit website
1996 Chrysler Concorde windshield wiper blade arms
Chrysler Forums
by DaCraigs
3M ago
I haven't for the life of me been able to figure out what wiper blade arm is for my car and I've unfortunately lost the manual. Is it small J hooks, large J hooks, I&L, pin arms, etc. Please help ..read more
Visit website
2004 gt turbo radio issue
Chrysler Forums
by deltas69
4M ago
New member here, so hi !! My wife has a 2004 gt turbo, two owner from new with 151,000 miles. It's driven maybe 50 miles per week..today 12/30/23 on her weekly trip to her mom's, the factory radio/cd begin to go off and on. Car continues to run fine, ..upon searching this I see it can be a common problem on this car. She's had it over ten years with nothing but normal care replacing iparts when needed as out older son is a mechanic. So has onyone had this happen to their radio...and if... 2004 gt turbo radio issue ..read more
Visit website
Camshaft sensors
Chrysler Forums
by Dana Wallace
4M ago
I have a 2012 Chrysler 200 with the 2.4 that keeps blowing camshaft sensors, usually within 3 weeks of changing. It's gotten to the point that the local parts stores won't let me return them for warranty replacement, saying there's another problem causing them to fail. When I tell repair shops the problem, they won't even look at it. There isn't a Chrysler dealer within a 2 hour drive, and I don't want to pay a tow bill for that distance. Has anyone else had this problem, and what solved it.... Camshaft sensors ..read more
Visit website

Follow Chrysler Forums on FeedSpot

Continue with Google
Continue with Apple
OR