Aussiefrogs » Peugeot Forum
111 FOLLOWERS
This section of Aussiefrogs is a forum especially for the Peugeot enthusiast.
Aussiefrogs » Peugeot Forum
11h ago
Hi everyone,
I have a RHD 307 CC cabriolet, here in Australia.
Anyhow 4 days ago, I went and replaced the airflow direction lever that attaches to the actuator. It is in a bugger of a spot for those with RHD cars, as the top screw to the actuator, is not easily accessible with steering column, but more importantly a wiring loom that comes out from behind the dash and is tied back to a bracket off the steering column, this wiring loom make it a job more on the difficult side, but I managed...
Read more ..read more
Aussiefrogs » Peugeot Forum
1d ago
Does anyone know where the fuel pump/abs relay is on a Peugeot 308 hdi 2010?
cheers ..read more
Aussiefrogs » Peugeot Forum
2d ago
Bunch of special tools peugeot posters
Rugby World Cup portable radio yes it works
Some 206 roof oil
A litre of lhm plus
Tu5jp4 balancer
Hedge trimmer
Injector seat cleaner and washer remover
New type genuine sphere tool
Pp2000 406 xantia adapter
2.0 Rhr timing tools
Piston micrometer
Dremel type tool
Bluetooth kit
Central locking kit
406 radio pins
Lots more
Make an offer ..read more
Aussiefrogs » Peugeot Forum
2d ago
Hello all,
Question is, are the rear and front bumpers the same on the 403 sedans and breaks.
Thanks,
Tommy ..read more
Aussiefrogs » Peugeot Forum
3d ago
2010 207cc (1.6, petrol, EP6C) had a few things when I got incluide anti pollution fault, generous smoke and oil consumption.
As mentiond in another thread, I've decided to replace valve seals, whole timing assy etc.
Peugeot guy in Burleigh also identified the inners of the currect cat it rattling with an upbeat noise in the casing.
I got a new cat from UK (Ebay) which cost a bit over $400 with shipping. It looks ok, but the only issue the downstream pipe is about 5cm too short.
The seller...
Read more ..read more
Aussiefrogs » Peugeot Forum
1w ago
to elborate on the title.
from cold my gti6 starts fine, idles fine, runs fine.
when it warms up it runs fine, and idles fine for about 10-15 seconds.
the idle then become a bit misfirey and slowly gets worse and worse.
if i blip the throttle it cures it again for another 10-15 seconds.
if i dont blip the throttle it eventually feels like its about to stall/die.
sometimes if im trying to accelerate off from a standstill it also feels like its about to die/stall unless i take it out of gear...
Read more ..read more
Aussiefrogs » Peugeot Forum
1w ago
I realise there are type 1 and 2 gearboxes, but is there a way to identify year of manufacture etc of type 2 boxes. Were all type 2 boxes configured as overdrive boxes. Also, is there a difference between sedan and commercial gearboxes ..read more
Aussiefrogs » Peugeot Forum
1w ago
Hi guys, trying to replace ARB bushes and one of the front subframe bolts is spinning but not coming undone. (Rear front subframe Bolt furthest from driver)
Is there anyway to access the nut from the other side?
Thanks ..read more
Aussiefrogs » Peugeot Forum
1w ago
Hi Guy's,
Im looking for an engine ECU kit with BSI, keys & cluster to suit a 2010 308 Manual Petrol.
Any assistance would be much appreciated ..read more
Aussiefrogs » Peugeot Forum
1w ago
Does anyone have a seal kit (i think the part number is 179868) that connects the exhaust manifold to the front exhaust pipe for a 405 Mi16 S2 XU10J4Z that they would be prepared to sell. These do not appear to be available in Oz through the usual outlets. The kit should contain a "conical" seal, two bolts, two springs, two washers and two nuts. Cheers Halsey ..read more