33 Engine Horse Power Kubota Diesel Engine 4x4 Power Steering 8x8 Gear Drive Transmission Fully Serviced with new battery in 2024 Loader Capacity approximately 1200 lbs. Skid Steer Style Quick Attach Tooth Bar 1000 lb. Ballast Tank not shown in pics. $20500 I'm in Albemarle, NC ..read more

Saw this on "Public Surplus . com" It has a little over 13 day's left on the auction, and is at $310 today. I can help with picking it up if someone here win's it. It's located at: Snoqualmie Pass Utility District 932 Hyak Dr E PO Box 131 Snoqualmie Pass, WA 98068 Dave Yelm, WA ..read more

Why would anyone chose an LX3520 instead of a L3302 - other than the mid pto ..read more

The LX3520 and LX4020 both got wider front axles. Did the LX2620 also get the wider front axle? The LX3520/4020 also got a loader with wider arms. Looks like the 2620 didn't ..read more

This is in really good shape and includes all mounting brackets, PTO shaft and manual. It was used to mow 1 acre. I believe it has less than 150hrs. I pulled it off because I already have a ZT. I'd consider a trade for a brush hog or partial trade for quick hitch, pallet forks, ect. Located in Vermont ..read more

WTB front loader for L3010 ..read more

I have an RTV500 615hrs. was running fine. I shut it off and went to restart and nothing. the 3 sensor lights in dash light up, but no power getting to starter. Battery is good. lights and dump bed operate. I changed the neutral switch and swapped out relays, checked fuses. what's left I might have missed ..read more

Recently purchased a non-running L35 from an older man. Needed a lot of TLC and maintenance to get running. It is now starting and running reliably, but about 30 seconds after starting, significant white smoke (smells like diesel fuel) blows out exhaust. Possibly sounded like fuel knock, May just be the sound of an older diesel. We thought stuck injector. Had injectors tested. 1 bad spray pattern, 2 were dribblers. Got new injectors installed. Same white smoke. When bleeding air out... L35 White Smoke ..read more

Looking for some advice, see below video. When following the proper procedure for removing the FEL on my 2023 LX2610 with 35 hours i am only able to easily remove the left pin. The right pin will rotate but requires a lot of force. I am on a level surface in my garage. I noticed if i put a 2x4 block under the left side of the bucket when attempting to remove the pins it does loosen up that right bit a bit more. I have yet to do any loader work besides moving some pallets around so i am not... LX2610 front end loader removal pin stuck ..read more

My clutch seems to be slipping on my L3901 Kubota. I can Let the clutch out all the way and the engine won't stall. I see in my manual that their is an adjustment behind the 2 bolt cover. I have rotated the flywheel to see the 3 bolts but not sure which way to turn the small head bolt. Any Ideas on my problem would surely be appreciated. L3901 Shuttle shift 303 hours. Thanks ..read more