Hey all, I got a new BCS 749 a couple years ago, immediately attached a BCS flail mower to it, and have been dealing with poor maneuverability ever since. The steering brakes are bad enough that I'd rather just manhandle it to turn -- even when I'm lifting the flail off the ground and fully squeezing one of the brakes it seems to only barely slow the connected tire. The differential lock is not engaged, I regularly use it for mowing straight lines over bumpy terrain and disengaging it on... Read more ..read more

Korean brands are out, heard too much bad stuff. Leaning towards the mid level models of the three in the subject line for new Fridge, stove (gas) and dishwasher. Going to go with the same brand cause the wife wants black stainless and I think each manufact. has it's own take on black stainless. You see good and bad reviews for each. I guess it is all about picking the look and features you like and crossing your fingers you don't get a lemon. Any other advice before I roll the dice ..read more

Came across this by mistake, but found it more than interesting to watch the entire clip. Very informative if you're interested in this kind of stuff. Since my dad enlisted in the Air Force in 1952, I remember him always joking that if he we're older than he was and if during WW2, he had no doubt that being 5'2" and 130 lbs soaking wet, he knows for a fact this is what he would have been doing ..read more

Hello, I have a 2022 Branson 5835R that will creep foward in neutral. Has anyone have information on this? Thankyou ..read more

"M" SERIES tractors are under a mandatory campaign by Kubota to replace the step and add a brace to prevent the step from breaking. If you have a "M" SERIES TRACTOR and this has not been done .... you are in danger from step breaking as you mount or dismount ..read more

Just put a repaired front end loader arm (leaking seal) back on tractor. Added hydraulic fluid to replace leak losses. New oil and oil filter. Level shows perfect on dip stick. Shred for one hour this morning and high temp light comes on. Stop engine and wait an hour. Went to replace fluid in radiator and it only needed about 16 oz of water. Screens are clean and fan is running. Started tractor and ran for 10 minutes. Overheating light on again. Anyone have any idea where to... Read more ..read more

Hello- what are the main dif. between these machines- Looking on line at preowned ones and it seems the 1600 series are going for more money than the 2638- Is the 1635/40 a premium version??- thanks for the help ..read more

Anyone have any experience with their MF 1635 Powershuttle hydraulic controller failing? thoughts. Mine has failed twice in 5 years ..read more

Has anyone experianced their hydraulic module failing in there MF tractor. The PowerShutttle version. Mine has failed 2 in the last 5 years, seems like a real high failure rate. thanks ..read more

Is front drive shaft removal nessacary for oil pan removal ..read more