Trying to connect an external gm 3 bar sensor and I can't. Does anyone have any advice on how to set it up correctly on the computer. I connected the sensor correctly ( i have ecu hondata 4.4.4 ..read more

2024 May 19th Sunday Mosport Outdoor GoKarting event 12pm - 3pm Sunday! 2022 Track Photos & Videos 2023 Track Photos & Videos Last event videos: Hello all... May 19th Sunday 12pm-3pm Mosport Outdoor GoKarting event - Touge.ca events 2024 ..read more

DIY: Converting primary o2 sensor from narrow to wide band for KPRO USE ONLY - Honda Civic Forum Electrical DIY - DIY: Converting primary o2 sensor from narrow to wide band for KPRO USE ONLY - So a while back Boilermaker posted My car got an IQ boost.... (https://www.civicforums.com/forums/46-honda-civic-members-rides/313318-my-car-got-iq-boost.html). In it you will find that I converted... www.civicforums.com Hello friends this post still available for kpro k20 /k24 ? Or only for d17 ? Thanks ..read more

What is the difference between the intake and exhaust valve seals? The guides seem to be the same diameter, are the valves narrower in the stem to justify the different seals ..read more

Bought a k20a head recently and trying to figure out if its any good. Got it for pretty cheap and my dumbass forgot to check anything due to the price. The code is a pna-2 ..read more

Hello all, still fairly new to the swap world and looking for a bit of help. Dealing with an EK K24A2 swap 6spd rsx type s trans. I am running a base map for a tsx through hondata. I am experiencing a rich condition at idle where my short term tips to 28% My air fuel is almost dead on stoichiometric possibly due to running closed loop option. I am new to making adjustments on hondata and can’t seem to figure out how to properly dial in a good street tune to stop my fuel burning issue... Hondata kproV4 tuning help ..read more

I was wondering if anyone could tell me what I need to do to up the redline on a k20z4 to about 9000 rpm. I know you need a better oil pump because the stock one doesn't flow well enough for those rpms but what else do you need to do to safely and reliabily hit 9000 rpm ..read more

If I recheck the torque on the vtc actuator will it harm the actuator. I replace the vtc actuator with the timing chain and to line up the timing marks used the actuator bolt to put it into position. It was torqued in the unlocked position then locked to time it ..read more

Like I said, I wanted to buy a K24A2 engine, though I don't know where to buy it from. I don't have any place to buy it from in my country, that is, Qatar, but does anyone know where I can order or ship from that is cheap ..read more

Hello everyone wanted to get your opinion on what my issue may be K20 on e85 got tuned afr was normal at startup and wot. Car would normally start at 16 afr and slowly go to 14.7 at idle once it was warmed up. Randomly two days ago i start the car and its super rich at idle and then became lean once the car was warmed up around 17-18 afr. wot is slightly high also around 13.5 - 14. My tuner told me it could be the fuel filter but. I re did my fuel system before the tune for e85 and i have a... Car running lean ..read more