Hiya, To preface: Brand new battery Continuity from green wires from alternator through harnesses is good. Both green wires go to a connector - one changes to blue and the other remains green. New voltage regulator from Amazon, I believe Standard Motor Products brand New voltage regulator pigtail Car starts, runs, drives. Aftermarket fuse box is installed in place of fusible links. When installing the external regulator - according to the image above... 87 GLHS - Battery not charging even with external voltage regulator - pinout does not match manual ..read more

I have a problem with my lebaron, New battery,coil,dist. Pickup,voltage reg. Car just stopped running and won't start. Getting no spark at cool or plugs. Any ideas ? Thanks ..read more

Hello all, I'm looking at a 1979 Plymouth Horizon with 55k original miles and a functioning Chrysler lean burn system on the original VW/Audi 1.7 engine. Does anyone have any information on these? All of my literature is for the 2.2/2.5 cars. I'd like help especially with figuring out what the pinout for the early diagnostic port on this car does. Were there ever scan tools that could plug into it? It's got different plugs from my DRB1 and OTC 4000E. Thank you, Isaak ..read more

Any tips/how to’s out there for replacing the blower motor on a P body? Reading the FSM but it’s not very detailed ..read more

Hi guys I’m in the process of installing the 4 wire O2 adapter harness I got from FWD Performance in my SC and the directions that came with it are a little confusing when it comes to where to splice into the 12v ignition source and the picture showing it is bad resolution so I can’t make out where they tapped into. It says to tap into the blue wire from the connector going into the vacuum solenoids. If someone can clarify this for me and give me pictures for reference I’d really appreciate... 1-4 wire O2 conversion harness install ..read more

Does anyone have some clean 83-85 dodge 600 fender vents L&R they want to part with. I need a set that hasn't been repainted a ton of times for my GLH Project the ones I have are rougher than I want to deal with. Thanks ..read more

I found some already rebuilt transmissions.I would like to find the parts to do it myself.I would like to upgrade parts for durability.No one has the OBX LSD anymore.Is there another option for the differentials?I can't find a Chromoly Steel end plate anywhere and would like one. I could have one machined, but that would be way more expensive.I also would like tips for upgrade parts like bearings, Syncros and maybe treating the shafts.I know parts are getting hard to find.I would like to... A520 rebuild or reman time.Need help finding parts ..read more

1987 Lebaron coolant temp sensor reads .13 which is below the .20 threshold.The other pin reads..02-.03 volts.I believe this side should not have any voltage?Is this a shorted circuit or do I need to go into the PWC or engine computer thingy?Thanks ..read more

Hey guys! Total forum noob here. I have a 1992 Spirit RT that my dad bought brand now and mom just gave it to me. I remember driving it as a teenager and cleaning the clocks of the 5.0 Mustangs. Being in the high altitude of Colorado, that car performed extremely well whereas the NA cars would choke due to the thinner air. A very fun car to drive. Dad stored that car for years in a hangar which that is still where I keep it when not using it. Anyway the shift cable bushings are all... 1992 Spirit R/T Shift Cable Bushings ..read more

1986 cs turbo z 51,000 original miles nice clean car $9000.00 ob. Offer ..read more