Z900 Forum
53 FOLLOWERS
Worldwide Kawasaki Z900 online community, with forum, news, photos, and much more.
Z900 Forum
3h ago
Bought a new 2024 z900 3 weeks ago and like it a lot. Have had a lot of bikes. Had a zx14r with a flash and full pipe and felt like i was just waiting to go to jail. This bike looks good and has enough power to have fun but not so fast that I am an idi ..read more
Z900 Forum
3h ago
No, you do not need to. The covers don't require the removal of all the bolts ..read more
Z900 Forum
8h ago
Hi, I’m planing to install RG Racing engine covers. I have a question about instalation: do I need to remove oil or is this not needed? I don’t want to get any leakage during instalation ..read more
Z900 Forum
2d ago
Afternoon People
I get my new 2024 Z900 later this week. Went for the Candy Persimmon Red/Ebony version. Going to notice a bit of a difference from my previous bike, a Moto Guzzi V85TT, but have had a Yamaha Vmax and Triumph Tiger 1050 Sport in the pas ..read more
Z900 Forum
2d ago
Thanks for this info.
I just had the same symptoms come up on my '21 model after an IAM Skills Day at Mallory Park on Thursday. Though the bike got me home ~100 miles without problems.
I've no idea what could have triggered it, and the bike was servic ..read more
Z900 Forum
2d ago
I have changed to Renthal bars (Superbike Low) on a couple of bikes (not Z900's though).
As received they weren't any shorter than the OEM bars, but I did chop about 20mm off each end. Also getting rid of the bar end weights and substituting short plu ..read more
Z900 Forum
2d ago
Hello everyone,
I'm a 36 yrs old man living in Belgium.
Proud owner of a Z900 from 2018. Bought it new and have only around 4000 km's done.
Hope to learn from you guys and your experiences ..read more
Z900 Forum
3d ago
Originally Posted by z900man
Just did this on my bike and will test it out tomorrow. I kept sliding all over the seat, hopefully this fixes it without spending money
Just came back from a test ..read more
Z900 Forum
3d ago
I found some time and changed the z900 fork seals a couple of weeks ago. All is well in the world again thanks again for the measurements ..read more