GoldenMotor.com Forum
59 FOLLOWERS
GoldenMotor.com is a place to get all the live information of discussions related to General Motors.
GoldenMotor.com Forum
1w ago
Quote from: Thingamajig on April 14, 2024, 01:44:11 AM
Is it possible to repair? are there any schematics for these controllers about?
Unfortunately I have not seen any schematics for the internal circuits ..read more
GoldenMotor.com Forum
1w ago
Hi all.
So I have an issue with my MP Edge - the throttle is stuck on.
After LOTS of diagnostics and prodding and poking with a multimeter, i've determined that the issue lies within the controller itself; as soon as I power up the hub/controller, meas ..read more
GoldenMotor.com Forum
2w ago
Had to do an update as I am so satified with this kit ... 4 years ..on my 3rd battery ..ride most every day 1 1/2 hours or 2 1/2 hours ..slow 8 mph .. I set the "cruise control" and adjust my petal effort with the 8 speed bike gears ..mostly stay ..read more
GoldenMotor.com Forum
3w ago
The controller in that video is a Kelly KLS-72100N controller that supports variable regen, but I seem to recall that the VEC500 controller does not support variable regen.
Regen on the VEC controller is either On or Off and should engage when t ..read more
GoldenMotor.com Forum
1M ago
A Youtuber (The Digital Mermaid) seams to have solved it:
https://www.youtube.com/watch?v=jN1rcPOXi2w
(I used to have a sailboat myself, but had a rigging failure ..read more
GoldenMotor.com Forum
1M ago
Update:
I sent a message to Golden Motor Support about the EZKontroller's support for the 10KW BLDC motor. The thread is below. I'm not sure why I'd need anything close to 800 amps of phase current since the 48v motor only appears to support 400 amps m ..read more
GoldenMotor.com Forum
1M ago
Very interesting. Golden Motor says the VEC500 is tuned for the 10 KW BLDC motor however it appears to be a weaker and less sophisticated controller when compared to their line of universal EZ-kontrol controllers. Specifically, the EZ-B481000 appears t ..read more
GoldenMotor.com Forum
1M ago
Also, for what it’s worth, there seems to be a safety mechanism in the software that remembers the lowest amp draw you pulled while overheating. Next time I took the boat out, I couldn’t pull more than 119 amps which is where it was when I overheated i ..read more