SN95 Forums
353 FOLLOWERS
The only site dedicated to the SN95 94-04 Mustang. A place to exchange information on tech, racing, performance, engine specific tech, buying, selling and sharing pics.
SN95 Forums
16h ago
I’m looking for the complete wiring harness for engine/dash for my 95 mustang gt. The previous owner has cut and rerouted so many wires a lot of features don’t work. I am planning on switching to power windows and power locks (If possible) was thinking about using cj pony parts 21 circuit universal harness to rewire the car. Has anyone ever used that wiring harness before? I will also need a new battery harness if anyone has any suggestions. Thank you for help. It is not swapped it’s a 302/5.0 ..read more
SN95 Forums
1d ago
These stupid misfires have been driving me absolutely nuts any input is appreciated (i’m NOT a mechanic)
for damn near close to a year now, i’ve had misfires on cylinders 3 and 4. I just took it into the mechanic about a month ago, they checked plugs, plug wires, coil pack, replaced MAF, New air filter, injectors (also ran 2 cans of seafoam injector cleaner through it with premium gas) and the shop did a vacuum seal check with their smoke detector.
Where do i go from here? what’s left to...
Read more ..read more
SN95 Forums
2d ago
Played around with AI picture generation and finished it in photoshop, just for fun ..read more
SN95 Forums
3d ago
Hi All,
I am in need of the fitting where the power steering pressure hose attaches to the pump. There are two types of hose ends. One has a flare fitting, the other uses a straight fitting with an o-ring. I need the flare type fitting. I'll buy the whole pump if necessary. I don't care what condition the pump is in, I just need the fitting. Please let me know what you have.
Thanks, CobraRGuy ..read more
SN95 Forums
3d ago
I just completed a PI head swap on my 97GT, stock NPI bottom end. I had a local machine shop do a valve job, install MMR stainless valves, guides and seals, BTR .600 springs. I used new lash adjusters, new timing chains. XE262AH cams that MHS degreed. The engine runs but is down on power. The tuner says the load is about 30% less than it should be. It’s loosing air somewhere. Comparession test shows 180 on all except #2 which is 170. Any ideas ..read more
SN95 Forums
4d ago
Just a few hours ago, I was out getting gas so I could make a pull and get a datalog. I met @Brad97 while I was there. He’s got a nice new edge, and I actually talked him in to joining the forum.
I’ll let him introduce himself ..read more
SN95 Forums
4d ago
Want to buy Service Manual and Owner's Guide for 1994 Mustang GT Convertible.
I would prefer digital copy download, so I can save on shipping fees, but books are okay as well of course ..read more
SN95 Forums
4d ago
Has anyone tried to purchase from them recently? Kaenen has a facebook page and their profile gives a telephone number and hours of operation? Literally the best aftermarket mustang hoods ever ..read more
SN95 Forums
4d ago
Hi All,
A fellow member of the NorCal Shelby Club, a professional car and engine builder, just sent out an email to the club that an engine he built for one of his customers is for sale since his customer passed away unexpectedly.
This is an all new engine built on an aluminum block and has all the best internals including shaft mounted rockers. This 351W is 445CID with 660HP and 600 lb-ft of torque all motor and weighs less than 400lbs. It is truly a beast!. It appears to be...
Read more ..read more