S197 Mustang Forum
351 FOLLOWERS
S197 Mustang is an online forum community about the 2005 to 2014 mustangs. A place to chat about DIY tech guides, racing techniques, tires, classifieds, vendors and more.
S197 Mustang Forum
6h ago
Hello,
I have a 2013 Ford Mustang GT with a Vortech V3 Supercharger amongst other supporting engine mods. Recently when making a pull in the car it jerks once super hard around 3-4k rpms before it gets into boost/power but then its smooth/normal all the way through the power band. It is super frustrating to drive with but is still making the power like it should. I have a SCT Tuner with customs tunes from Lund and tried reflashing the tune but no change was made. Does anyone have any idea...
Read more ..read more
S197 Mustang Forum
15h ago
Hello,
I have a 2013 Ford Mustang GT with a Vortech V3 Supercharger amongst other supporting engine mods. Recently when making a pull in the car it jerks once super hard around 3-4k rpms right before it gets into boost/power but then its smooth/normal all the way through the power band. It is super frustrating to drive with but is still making the power like it should. I have a SCT Tuner with customs tunes from Lund and tried reflashing the tune but no change was made. Does anyone have any...
Read more ..read more
S197 Mustang Forum
1d ago
Hello! Im looking for (photo attached) everywhere. I have Mustang from 2005 4.6 v8. Anyone can help ..read more
S197 Mustang Forum
1d ago
New member here….I've got a 2012 GT which is basically stock. I would like to upgrade the suspension for better ride and handling if possible. Looking for suggestions for specific upgrade possibilities. I’m not particular savvy mechanically which is why I’m asking for specific recommendations. Thanks ..read more
S197 Mustang Forum
1d ago
dear shelby fans am in need to see where is my car at and use it as a reference point 60-130 time for a stock 2013 shelby gt500 or mildly bolts on like 67 vmp TB JLT intake catless and a tune ?
Thank u appreciate the help in advance ..read more
S197 Mustang Forum
2d ago
I installed Pypes catted X-pipe SFM26E on Sunday. I noticed that I didn't have any front isolators for the prongs on the X-pipe. I don't think I've ever had them. I have isolators at the rear that hold up the back exhaust pipe. From https://iihs.net/fsm/?d=310&f=Exhaust System - Exploded View.pdf&p=2, I believe the part # is 5A246.
My question is when did Ford stop installing front isolators?
I don't think I've ever seen them on my car. I have 143k miles on my car, so I...
Read more ..read more
S197 Mustang Forum
2d ago
So my 2011 GT decided it doesn't like lights. One day, the low beams on both sides decided to just stop working all together. I had the Raxiom s550 style headlights in it with a set of Morimoto HID's. I figured maybe a fuse blew. After searching around, I realized there isn't a fuse for the headlights. I checked the voltage at the plug for both and nothing. This led me to believe the switch went bad and I had a few others tell me its a common occurrence. So I ordered a new one since they are...
Read more ..read more
S197 Mustang Forum
3d ago
Anyone know where this ground lands. One end is the red…I think the other end is on the back of the drivers side head but not sure ..read more
S197 Mustang Forum
3d ago
Needing the connector from this harness that goes to the fuel pump. It was brittle and cracked when I went to swap pumps ..read more
S197 Mustang Forum
3d ago
I bought some vector v2 taillights from American muscle and have had them on the car about 2 years now. I think my module finally failed. The middle bar will not light up as bright anymore. It's so dim it's almost not lighting up. The inside and outside bars are still very bright. I been trying to see if I can take it apart to fix it but it seems it's a sealed unit. Frustrates me that I was not able to get a warranty for these, they were around $400! If anyone has any tips or advice please...
Read more ..read more