Modded Mustangs
353 FOLLOWERS
A forum community dedicated to all Ford Mustang owners and enthusiasts to discuss about racing, builds, modifications, troubleshooting, maintenance, performance and so on.
Modded Mustangs
3h ago
Just got my Bama Performance tuner in today and so far i am thoroughly impressed! My question is what is the difference between a 93 Performance tune and a 93 Race tune? I am debating on running the 93 Race all the time, but since this is my DD I just wanted to make sure it's safe ..read more
Modded Mustangs
3d ago
Looking for any info on smaller pulley size for the m90 charger on a roush 360r. From what I could dig up it looks like a 2.56 is the smallest pulley I can run without heat soaking. Anyone running this on a 360r? Stock belt no issues ..read more
Modded Mustangs
3d ago
Hey guys, new member here and new mustang owner. A few weeks back I had bought a 97 gt 4.6l auto with 106k miles on the motor and a new trans in it. It was 100% going to be fixer upper but was running and driving. The main issue besides the dry rotted tires is there was this slight knocking sound whenever it was put into gear that didn't happen all of the time and it wasn't as aggressive like the average rod knock. When it idles its great until the rpm goes up. The knocking doesn't get any...
HELP! I DONT KNOW THIS KNOCK/TICK ..read more
Modded Mustangs
6d ago
New (38 miles) take offs. Pirelli P Zero (PZ4) sizes 255/40-19 & 275/40-19. Located at Appleton WI 54913. $650 ..read more
Modded Mustangs
6d ago
I wanted to share some exciting news for those looking to upgrade their exhaust system. As a passionate gearhead myself, I'm always on the lookout for great deals on top-notch performance parts.
From April 1st to May 31st, 2024, CARiD is offering incredible discounts on Pypes Exhausts products. You can save up to $40 on a wide selection of their high-quality...
Roar into Spring with $40 OFF Pypes Exhausts at CARiD ..read more
Modded Mustangs
1w ago
16 Mustang GT California Special here with 48k miles, only have one issue that I can't seem to figure out. Check engine light for a O2 sensor. Replaced the O2 sensor, still the same issue. I've tried every single possible fix on Google that I could find and still it won't go the hell away, so at this point I'm just living with it and ignoring it's even there. It happened after my two 10 inch JL Audio subwoofers blew and had to replace them with one Alpine Type R Subwoofer.. So I'm not sure...
P2254 CEL Code Help ..read more
Modded Mustangs
1w ago
i've got a '01 mustang base model with a 3.8l V6 that is having misfire issues. it started out with just cylinder 6 but progressed to cylinder 5. i put all new plugs and wires in it when i got it and replaced the coil pack with one from Napa. it was still idling rough at a complete stop. i went to O'Reilly's and ordered a motorcraft coil pack and put it in there. i recently drove it from STL, MO to Warrenton, MO and it would start to lose power. i swapped the Napa coil pack back in and now...
cylinder 4 misfire ..read more
Modded Mustangs
1w ago
Has anyone had a P0059 HO2S Heater Resistance (Bank 2, Sensor 1) code after a long tube header install? I have driven 400 miles since I installed my headers and the light just started coming on ..read more
Modded Mustangs
1w ago
anyone know where the cam position sensor is located on an 04 mustang gt SOHC? I think its in front on the drivers side behind the power steering fluid resivor that pluds directly into the head. Yes, no, maybe? Also what are the symptoms of a bad cam position sensor? My car has a rougher idle since last night, lost power, very rough start has to turn the key 2X, and gas milage is horrible. Plus Advanced Auto Parts code scanner red "cam position sensor malfunction." anyone know anything ive...
cam position sensor went bad ..read more