Corral Forums
354 FOLLOWERS
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, production numbers, VIN decoders, modifications, troubleshooting, power adders, DIY tutorials, and more!
Corral Forums
5m ago
I wanted to share some exciting news for those looking to upgrade their exhaust system. As a passionate gearhead myself, I'm always on the lookout for great deals on top-notch performance parts.
From April 1st to May 31st, 2024, CARiD is offering incredible discounts on Pypes Exhausts products. You can save up to $40 on a wide selection of their high-quality...
Up to $40 OFF Pypes Exhausts at CARiD - Limited Time Offer ..read more
Corral Forums
10h ago
Novi 2000 Head unit, no touchdown,shaft is tight not worn out.Ready to Run.I am asking 1800.00 don’t miss out these are hard to find.Let me know I will ship on your dime ..read more
Corral Forums
15h ago
Hello, does anybody know what lights should turn on when i start my car? What are the sequence of lights if everything works correctly? My chime does work.
(1991 mustang GT 5.0L manual)
All these lights come on for a few seconds, and off after starting car.
airbag
check engine
seatbelt (if I unbuckle seatbelt should it not chime and turn on light? Mine does not with car in N door closed and running)
brake light (off after releasing ebrake)
battery
These...
Foxbody 1991 warning lights, installed new PCB ..read more
Corral Forums
17h ago
Good condition GT40 intake manifold and tubular upper. Comes with 3/8” spacer if needed. No issues with manifolds. Located in Mesa Arizona. Buyer pays shipping ..read more
Corral Forums
18h ago
Seller had good communication, fast shipment, and everything arrived as described. Another awesome transaction found in the classifieds ..read more
Corral Forums
23h ago
My poor old 64 1/2 convert has been essentially down for four years. It’s major problem was an intermittent fuel pump, which I fixed.
I had it running sort of ok, except the high idle circuit was screwed up - it would go to 1200 rpm after it warmed up.
Had the carb rebuilt. Autolite 2100 - used to be easy to get this done, but no more. $500, and still high idle problems.
Took it to a shop that had previously fixed another Mustang quite well (same engine, but auto trans).
They swore it...
Mustang 289 Carb Problems ..read more
Corral Forums
23h ago
If I understand correctly, its seems agreed for a mild setup to NOT exceed 36deg total timing. But I'm trying to find out what's the best rpm range to be considered 'all-in' ?
My current setup
Edelbrock 6037 with 1.90" intake valve & 1.6rr
Weiand Stealth w/Edelbrock 1406
Melling SYB-51 cam (oem replacement cam), stock lift but just a tad more duration
Aero 2-stage regulator set at 6psi (running efi pump)
Champion RC12YC gapped at .043
Present ignition:
Chinesium HEI (yeah yeah, I...
Carb setup - Seeking Input on Timing Curve ..read more
Corral Forums
1d ago
About to do the plugs and noticed the car has flat washer plugs In it. Does this cause a loss in compression or ? I have the correct taper plugs to go in just want to know what using the wrong plugs will do. Car definitely doesn’t pull as strong from 3rd gear and up ..read more
Corral Forums
1d ago
Is Ford admitting that the pcv system we know and hate is actually less than optimal?
Ford Motor Company Plans to Immortalize the ICE With New PCV ..read more