Color Printing Forum
277 FOLLOWERS
Printing Press & Color Printer Forum to discuss digital color printing, short-run color laser printers, color copiers, & RIPs, digital presses, 4-color offset press printing, high-end offset printing, and new printing equipment from prepress to finishing equipment.
Color Printing Forum
8h ago
hi I got a code error 807 in my polar cutter 137 x anyone knows what I is ??
please help ..read more
Color Printing Forum
18h ago
I have a L40P 4/c press 2000 vintage serial #134 having trouble with converting from straight to perfect it stopped after face B check position that square is green the next square on convert chart is face B release....when I go to trouble chart it shows ...surface B suction head drive cam trouble......any help would be appreciated still waiting on komori to call back ..read more
Color Printing Forum
1d ago
Hello
I remove the fake plate and replace it, but it still doesn't go beyond 7cm.
There is nothing in the slot where I marked, it is empty, I think the button is missing, where can I find it ..read more
Color Printing Forum
2d ago
hi, does any one know, what the small "toggle " switches do on a grafix spray powder device do? i know that they make the device pulse.Do you set them according to the paper size? As in 450mm or 045cm.The guys seem to be running way to much powder on jobs , thought id have a play but unfortunately no manuals.
cheers ..read more
Color Printing Forum
2d ago
Hi.
The Roland 700 I'm currently working on prints alot of board 450 mic-600 mic and the feeder foot always snags the sheet as it picks it up.If you move the feeder head outwards it will pick up doubles etc.
Is there a foot for board and one for paper.?
The sheet separators are tapered and seem very flimsy for board and wear out Daily .
When the press is running, everything is on a knife edge with numerous stoppages.
We have tried running off the front sensor rather than the pressure foot...
Feeder foot ..read more
Color Printing Forum
3d ago
Hi,
I'm evaluating purchase of a super-cheap (150€) nearly mint (<10K pages) WorkCentre 7835. The printer has no toners so I can't use installed toners' part number as a reference.
Whether it is metered or sold I don't mind (I can buy corresponding toners or replace chips) but I just want to be sure it's not in a "sold but put a metered toner so now a pin will be needed or it won't print at all" state.
Any idea how can I check from the panel what the status is?
Thanks ..read more
Color Printing Forum
4d ago
At the moment i am having polar 90 at my premise and i am planning to move that to my back side store as the store entrance is small i am unable to move it fully.
Can any one advice me whether it is possible to move the polar cutter by removing the table, motors, glass and other components of the polar cutter.
Please refer to the attached images of the polar cutter ..read more
Color Printing Forum
4d ago
Moving a Polar 78 on the second. It's in a building that can't fit a forklift. Does anyone here have any experience moving a mid sized Polar with a gantry crane? Any advice would be greatly appreciated ..read more