Sea-Doo Forum
19 FOLLOWERS
Sea-Doo Forum provides a community for all PWC, Jet Ski, and jetboat owners.
Sea-Doo Forum
16h ago
I have a 951 that has a broken oil injection nipple. How do i go about getting this out and also getting a new one ..read more
Sea-Doo Forum
20h ago
Hello i have a 2002 787 rfi that is driving me crazy when I got it, it wouldn't run at all in the water, but it would run on the trailer things that I have tried are: I replaced the rotary valve and sent the rotary valve cover to SBT to have it resurfaced because it was way out of spec that's when it would finally run and start in the water, but it runs poorly I have replace the fuel pump. I have verified that there is plenty of spark at the spark plugs. I have replaced the spark plugs. I...
Read more ..read more
Sea-Doo Forum
20h ago
Hello i have a 2002 787 rfi that is driving me crazy when I got it, it wouldn't run at all in the water, but it would run on the trailer things that I have tried are: I replaced the rotary valve and sent the rotary valve cover to SBT to have it resurfaced because it was way out of spec that's when it would finally run and start in the water, but it runs poorly I have replace the fuel pump. I have verified that there is plenty of spark at the spark plugs. I have replaced the spark plugs. I...
Read more ..read more
Sea-Doo Forum
1d ago
Hi All,
Could you recommend the bimini size for the 2008 Speedster 150?
72" Long,
Height 36" or 46" ?
Wide 73-78" or 79-84" or 85-90" ?
Appreciated for some manufacturers and links.
Thanks.
Max ..read more
Sea-Doo Forum
1d ago
Some history:
Bought a used 2006 RXT, no issues disclosed to me other than the owner said at some point he had the supercharger rebuilt.
Initial run had a problem with very low top speed and eventually overheated. Found and fixed that problem (heat exchanger and seal between it and hull).
After that was fixed on the next test ride i had a moment when i was coming off the throttle where i got a trouble code and went into limp mode. turned it off then back on, ran fine back to the dock but i...
Read more ..read more
Sea-Doo Forum
1d ago
I have to say my most miserable Bastid award goes to my current project 1996 Seadoo Speedster boat. It is at the top of my list because I don't like working on boats so it is an enigma why I even bought it. You can't get to parts without hanging over the side, and this SOB had too many idiots working on it before I ever touched it. Most skis need everything and that's what I do straight away. Being a twin engine boat this bastid needed everything TWICE. I wish it could tell me its...
Read more ..read more
Sea-Doo Forum
2d ago
Hey all, new guy here (to the forum, pwc’s and 2 strokes)
I changed my carbon ring last night and all went seemingly well putting the jet pump back on, but after I bolted the nozzle to it I noticed a problem as I was hooking up the vts and steering.
The vts rod is far enough out that when connected it tips the nozzle down so for that left and right motion is restricted badly.
Not sure if I need to just “trim up” with the controls, or adjust the linkage at the nozzle or if I did something...
Read more ..read more
Sea-Doo Forum
2d ago
Has anyone installed a sonar on a speedster? If so, any recommendations? New to the waters in my area and want something for mapping and water depths. Thank you in advance ..read more
Sea-Doo Forum
2d ago
Anyone sparing out parts for a 2009-2012 Challenger 180? I am looking for a rear starboard seat cushion. Those model years have the notch in the cushion for the handle. Thanks ..read more