Hi I have confirmed that the idle control valve is working now and again. Which when it isn't it put the EM light on. Can I get a replacement from somewhere. Are they a bosch part ..read more

anyone with a 125 TNT had an ecu remap done or power commander fitted ..read more

Hi guys anyone got any tips on how to remove the alternator female joint? I already removed the bolt and washer but the joint is not moving at all. Thanks ..read more

Hoping there is such a thing as a fault code reading software and hardware (cable). If so where can I purchase them from. Many thanks ..read more

Hi all, New Benelli owner here, and first time posting. I got a Benelli Leoncino 250 less than a year ago (~3000km now) and no issues with the bike except one which is more annoyance than a real issue. When cold on first start if you rev the bike on release it bogs down and stalls. Same happens if you ride it right away.After that its hard to start without applying full throttle. If you let it idle for couple of min, runs ok no issues. Went to the dealer for a week and they didn't find... Leoncino 250 cold start issues ..read more

Just drained the bike of coolant and about 2 litres came out. Still see some in the catch tank which won't come out. Disconnected flow/return from the pump and removed drain screw from pump as well. Flushed out with water until clear as i've changed antifreeze manufacture. Both OAT antifreeze. On refill I can only get 1600cc back in. I've run the bike up to temp (which it achieves quickly) but then sticks at mid temp gauge no fans run. I’ve tilted bike side to side and and removed pressure... 2010 TRE K 899. Coolant refill ..read more

Hey everyone, or anyone reading this. New member here. Joining this community to learn about my new ride. After much thought and consideration on what I should buy to carry out my plan ..read more

My Benelli TNT 135 is turning off and losing power while riding to the point it turn off while on throttle. It also idles weird it’s a little under 2k and flicks, u can hear the rpms changing. When approaching a stop the rpm goes to 1k and struggles to go back up. It has also idled under 1k. I changed the tps sensor and I think it made it worse. I don’t get a check engine light until it turns off. Some times it turns on right away and sometimes it struggles. I don’t ride much and take care... Benelli TNT idling weird and turning off constantly while riding and at idle ..read more

Looking for a Power Commander for my 2007 Naked TRE 1130. Thank you Erick ..read more

Looking for a Power Commander for my 2007 Benelli 1130 Naked Tre. dylanes21@aol.com ..read more