Gonna be making more of this frame. One will be set up for an Ironhead by request. And making several high mid set ups. Will be complete with cable, clamps, controls, master, hardware and linkage. submitted by /u/trev0rrrrr [visit reddit] [comments ..read more

Hey guys, ive got delkron cases on my shovelhead which dont have the usual mounting hole to attatch a carb support bracket for the super e. Has anyone had experience with this? If so, how did you go about mounting a support? submitted by /u/Klutzy_Dig526 [visit reddit] [comments ..read more

❗️FOR SALE❗️ ❗️RIGID SANTEE FRAME ROLLER ❗️ 8 over 35 mm front end Dual piston PM caliper Front and rear mags front wheel is a 7 spoke off a yamaha nobby tires front and rear, rear tire practically new front is in good condition Frisco style low tunnel tank clean on the inside Badass riser setup with 2” extended slugs Nice setup to get your tough guy bike on the road Throw in your motor and trans and call it a day ! ❗️SHOVELHEAD AND EARLY BIG TWINS ONLY❗️ ❗️BIG TWIN EVO’S WILL NOT FIT (w/o modification to the frame)❗️ ❗️ NOT PARTING ANYTHING OUT IT ALL GOES TOGETHER ❗️ ❗️ NO PAPERWORK ❗️ ❗️1 ..read more

Is you get most of your work done for pennies on the dollar! This being his first time doing line work & more flashy work, he did pretty damn good too! submitted by /u/It_Puts_Teh_Lotion [visit reddit] [comments ..read more

The bike has gone throw A LOT of renditions but this is the latest. Camping rack is TBD if kept it not. It's not a Softail any more but an actual hard tail and chain conversion is coming next. submitted by /u/BlackBeard-0 [visit reddit] [comments ..read more

Fun build! Month progress. Nearly finished. submitted by /u/biggsss739111 [visit reddit] [comments ..read more

Hey everyone, I drove past a pawn shop today and they had what looked like a chopper that has seen better days for sale. They want $3300 for it. I’m looking for a project bike and this could be fun. What do you think it’s true worth is? I’m gonna go back and look at it, but they told me that it doesn’t run. I’m assuming $2000 at most. I’m willing to pay a little bit of a premium just so I could have it and start tinkering. What do you guys think? submitted by /u/Dorkmaster79 [visit reddit] [comments ..read more

Been picking away at this thing for about 4 months with a friend.... we've gone through the bike head to toe ...almost there. Just finished up the paint recently! submitted by /u/Dandermann2 [visit reddit] [comments ..read more

submitted by /u/Eazy_Rider831 [visit reddit] [comments ..read more

submitted by /u/SirLancelot95 [visit reddit] [comments ..read more